The key turned the engine off in the driveway and now refuses to come back out. Wiggling it, pushing the shifter through every gear again, even leaning gently on the wheel; the barrel keeps holding on to it regardless.
A key that has snapped off inside the ignition barrel is not the end of the key, or of the barrel. The broken piece is drawn out with hooked or spiral tools built for the job, without pushing it further in, and the cylinder is checked afterward for the wear that likely caused the break in the first place. A fresh key is then cut and tested before the visit ends.
Sound familiar?Cobourg
Ignition Lock Repair · Cobourg
Scene 1
Before deciding how to repin or replace the ignition cylinder, the locksmith asks about the rest of the vehicle. Do the doors and the trunk share a key with the ignition, or does one of them already need a different one? Keeping that arrangement in mind before any pinning begins means the finished repair either preserves a single working key across the vehicle or explains clearly why one lock now sits apart from the rest of them.
Scene 2
Reaching some ignition cylinders means removing steering column trim and shrouding first, and that work is done with the fasteners and clips the vehicle was built with rather than force. Wiring and components near the column, including anything related to the airbag system, are left exactly as found and never disturbed unnecessarily. Once the cylinder is serviced or replaced, every panel and clip goes back the way it came off, so nothing rattles or sits loose afterward.
Scene 3
Where the ignition showed signs of an earlier forced attempt, the replacement hardware carries none of that history forward: new pins, a new key, and a housing that has not been tampered with. You are shown the old part before it is handed over or taken away, so the vehicle's ignition starts its next chapter with hardware nobody has already tried once to defeat.
What shapes the quoteCobourg Lock & Key Co.
FeesSame any hour
It is mostly inconvenient rather than urgent, though it is worth having looked at soon since a stuck key often means a wafer or the steering-lock mechanism is not releasing the way it should. Forcing it risks snapping the key or damaging the barrel further, so the safer route is to leave it be and have the mechanism assessed and freed properly.
In most cases, yes. Whether the cylinder is serviced in place or replaced outright, it is pinned to match the key you already carry wherever the vehicle's design allows it, rather than handing you a second key to keep track of. If the vehicle's own hardware makes that impossible, you are told before any work begins, not afterward.
Yes, and it takes only a moment when the paperwork is on hand. A vehicle permit or registration document matched to identification settles it in most cases. If the vehicle is a rental, a fleet vehicle or belongs to someone else, a lease, a work order or a call to the registered owner fills the gap. This step protects every vehicle owner who might one day call about their own ignition.
NorthumberlandOntario
Ignition Lock Repair · Alnwick/Haldimand, Brighton, Cramahe, Hamilton, Gosport, East Colborne, Coverdale, Norham, Codrington, Orland, Smithfield
Every square is one home in a hundred.
On-site assessment
The key turned the engine off in the driveway and now refuses to come back out.
(289) 677-1674, open 24/7.
On-site assessment preferred · (289) 677-1674, open 24/7
