Skip to content
CobourgLock & Key Co.Open 24/7 (289) 677-1674
Technician inspecting splintered wood around a door-frame strike plate. — Break-In Damage Lock Repair, Cobourg

Lockouts · Cobourg

Break-In Damage Lock Repair

The shop's aluminum door has a bent meeting stile and the hookbolt is jammed half out. The alarm did its job and the display is untouched, but the entrance will not close properly and opening time is hours away.

In plain words

Break-ins seldom come through the door with the strongest lock. Sliding patio doors are lifted off their track or pried at the latch, the garage man-door carries a light knob lock, a basement walkout is out of sight, and a storefront's narrow-stile deadbolt sits behind a bendable aluminum edge. Each needs its own repair: anti-lift blocks and a foot bolt for the slider, a proper deadbolt and reinforced strike for the side door, a latch guard and repaired stile for the shop. Break-in damage lock repair covers whichever opening was attacked and looks over the others while the tools are already out.

Sound familiar?Cobourg

The call
The back door looks closed until you touch it. The edge is crushed where a bar went in, the latch is bent sideways, and the door swings free with a gentle push no matter how you turn the key.

NextHow the visit goes

Break-In Damage Lock Repair · Cobourg

How the visit goes

Illustrative locksmith scene — Cobourg
  1. Scene 1

    Does the door still hang true

    An impact hard enough to break a strike usually moves the door as well. The locksmith checks that the door sits square in its opening, closes on its weatherstrip without force, and that the bolt lines up with its pocket rather than dragging on the strike lip. Hinge screws are tested for grip, since a kick can pull them from the jamb even on the side that was not attacked, and the hinge leaves are checked for bending. Manufacturers treat strike position, pocket depth and door alignment as working parts of the lock, and a repair that ignores them produces a door that locks badly the day after it was fixed.

  2. Scene 2

    Sliding doors and garage entries

    A forced patio slider is repaired by putting the panel back on its track, replacing the broken latch or fitting an auxiliary bolt into the frame, and adding the pieces that stop the next attempt: anti-lift blocks in the upper channel so the panel cannot be raised off its rollers, and a foot bolt or pin lock at the bottom. A garage man-door that carried only a knob lock gets a proper deadbolt, a boxed strike and long hinge screws to match the front of the house. Where an overhead door was the way in, the emergency release cord is shielded from outside reach and the opener remotes are reprogrammed.

  3. Scene 3

    What another trade still needs to do

    Locksmith hardware fixes a great deal, but a shattered frame, a broken door slab or a smashed sidelight belongs to a carpenter, door installer or glazier. When that is the case you leave with the opening secured, a clear list of what the other trade needs to do, and hardware chosen so it transfers to the new frame or door rather than being bought twice. The temporary securing is designed to hold comfortably until that work is booked. Insurers let you choose your own contractor, so the list is written for whoever you pick, and the locksmith is available to fit the final hardware once the woodwork is done.

In the van

  • Jamb repair plate
  • Replacement cylinder or core
  • Security strike box
  • Grade 1 deadbolt with one-inch throw
  • Anti-lift blocks and foot bolt

What shapes the quoteCobourg Lock & Key Co.

Door and frame material
A wood jamb over a stud takes standard reinforcement. Steel frames, jambs on masonry, fibreglass doors and aluminum storefront stiles each need their own fasteners and methods, which changes both labour and parts.
Keys cut
New keys are cut from the fresh pinning and counted separately: enough for each adult, the dog walker and a trusted neighbour, however many you decide you need.
Door edge reinforcement
A wrap-around edge reinforcer is added when the wood around the bore is crushed or split. It is a separate part, chosen to suit the door thickness and the hardware going into it.

FeesSame any hour

Have it ready

Before you call · 0 / 3

(289) 677-1674

Short answers to common questions

What should I have ready when I call about a break-in?

Whether the police have been called and any occurrence number; whether everyone is safe and the property is empty of intruders; which opening was forced and whether it closes at all; whether the damage is to the lock, the frame, the door or the glass; whether keys, remotes or codes were taken; whether you own, rent or manage the property; and whether there is glass beside the door. Photos on your phone help the locksmith bring the right hardware.

They did not get in. Does the door still need attention?

It does, because the force went somewhere. A lock that held against a kick or a bar often leaves a bent strike plate, loosened screws, a gouged door edge and a bolt that now binds where it met the strike under load. Each of those makes the next attempt easier. The visit checks every part that took strain, replaces what bent, reinforces the strike and hinges with long screws, and confirms the bolt throws cleanly, so the door is stronger than the one that was tested.

The intruder found our spare keys. What should be rekeyed?

Everything those keys fit. That usually means the front, back and side doors, the garage man-door, the mailbox and any padlocks, and in a rental the suite door with the landlord's involvement. Rekeying changes a serviceable cylinder to answer to a new key, and a cylinder that cannot be rekeyed is replaced instead. Doing every affected opening in one visit, keyed alike where the cylinders are compatible, means no forgotten door still answers to the stolen ring.

Cobourginformation

NorthumberlandOntario

Town
Cobourg, Northumberland
In business
13 years
Hours
Open 24/7
Nights, weekends and holidays, same fees
Visits
On-site assessment preferred. Request a visit or call.

2021 census: what it means at the door

Every square is one home in a hundred.

  • 52 in 100 homes · older homes
  • About 52% of homes in Cobourg were built in 1980 or earlier, according to the 2021 Census.Established homes often have non-standard bores and backsets from an earlier generation of hardware. A locksmith working in such an area carries adapter plates and cylinders in the older sizes, so an upgrade fits the existing door instead of forcing a new one.
  • Single-detached houses make up about 58% of homes in Cobourg (2021 Census).Neighbourhoods of houses beside townhouses and low-rise buildings have a range of door constructions: solid wood, steel, fibreglass and metal-clad. A locksmith who works in such an area is used to fitting hardware to all of them without new holes.

Source: Statistics Canada, Census Profile

Open Cobourg in Google Maps

On-site assessment

Request a visit.

The shop's aluminum door has a bent meeting stile and the hookbolt is jammed half out.

(289) 677-1674, open 24/7.